Engineers at UC San Diego have built the fastest soft robot ever recorded, a six-legged machine that hits 4.72 metres per second without a single electronic component. The device, detailed in Science Robotics on November 18, is 3D-printed in one piece on a desktop printer using a single material, and runs entirely on pressurized air moving through internal channels.
The Technical Reality Under the Hood
The robot comes from the Bioinspired Robotics and Design Laboratory at the Jacobs School of Engineering, led by postdoctoral researcher Yichen Zhai and Professor Michael T. Tolley. Their 2022 prototype, also air-powered and 3D-printed, topped out at 4 centimetres per second. The bottleneck was fundamental: the structure could not withstand the airflow or pressure required to go faster.
The new design solves this by scaling the internal architecture up. Larger, stronger chambers and valves handle higher pressures, but that introduced a fresh problem. At speed, the robot became wildly inefficient, exhausting high-pressure air that still held usable energy. The fix, as ever, is in the detail that matters: the team adapted the compound steam engine principle. Air expands first through small, high-pressure chambers to drive the valves, then passes into larger, low-pressure chambers to drive the legs, extracting work twice from the same charge of air.
Why Electronics-Free Matters for Wearables
Soft robotics aims to build machines with physically flexible bodies and electronics, but the compliance that makes them safe for human contact also makes them difficult to control. Traditional rigid electronics are a mismatch; they create hard points where soft materials tear, and they need batteries, wiring, and shielding that defeat the purpose of a compliant system.
An electronics-free pneumatic logic sidesteps all of that. The UC San Diego robot demonstrates that complex gait control — six legs coordinating at nearly five metres per second — can be embedded in the fluidic circuitry itself. For consumer wearables, this points toward assistive exosuits or rehabilitation garments that are genuinely soft, washable, and free of rigid battery packs. The lab describes the machine as a high-speed running machine produced from inexpensive materials; the desktop printing route only lowers the barrier further.
The Landscape Shifts
The field has been edging this way. At the University of Alabama, Dr. Vishesh Vikas’s Agile Robotics Lab has been wrestling with the interface between soft and rigid components, using tendon-like semi-rigid materials to stop soft actuators from shearing at the joint. In South Korea, DGIST researchers recently demonstrated mechanoluminescent fibers that glow under strain, offering sensor feedback without wires. But the UC San Diego result is a step change: a fully integrated, monolithic system that runs fast enough for practical locomotion, not just demonstration.
The study was published in Science Robotics on November 18, 2026.
Sources
- Soft robotics
- UA’s Agile Robotics Lab pioneers a new kind of robot
- 3D-Printed Electronics-Free Soft Robot Reaches Record-Breaking Speeds
- Tiny, soft robot glows green as it stretches its limbs
- San Diego Robotics Forum Highlights AI, Compute and New Materials
- The Robotic Tactile Sensors Market – Global Forecast to 2036 | Market to Reach $2.45 Billion at 20.5% CAGR as Humanoid Robotics, Safety Compliance, and Contact Imaging Accelerate
Photo: Franck V. / Unsplash (Unsplash License)





